Ramsey Electronics PG13 Manuale delle Istruzioni Scaricare il pdf (Pagina 19)

IG7 Page 19

 21. Now solder the final larger white wire of the Ion Generator to the bare

pad provided on the back side of the nail board in the upper right corner.

 22. Check nail positions within the copper tubes and make sure they are

approximately centered. They don’t have to be right in the middle but if

they are cocked at an angle, you may wish to heat up the solder and re-

position the nail to center it properly.

We’re done with the assembly of your Ion Cannon! Now is probably a good

time to re-read the safety precautions before you plug it in.

The Finished Product!

Attaching the Boards To the Main Board

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Nessun commento

Ramsey Electronics PG13 Manuale delle Istruzioni Pagina 19